The most powerful range in the uk up to 60 danm off the shelf.
Brand new electromagnetic hydraulic clutch and pump assemblies are commonly used in marine, agricultural, offroad and general industrial applications such as remote hydraulics in service trucks, boats, trucks with automatic transmissions, farm tractors and snow ploughs.
During assembly please make sure there is no oil or grease traces on the pulley surfaces which must be completely dry and clean.
Running in of the full range of electromagnetic clutches is required to obtain the desired rated torque value. Running in is carried out by engaging and disengaging clutch at high speed several times with the pump in the unload position.
When assembling the electromagnetic clutches with any front driving flange please check for correct coupling alignment, but do not exceed rated torque because this would cause slippage of the contact surface where the belts are located. This stage must not last more than 5 seconds as coils within the clutch will burn out.
Mounted inline with engine belt 2 groove pulley Clockwise rotation - Max 5000rpm Available electrical inputs available are 12 volts 4.55A and and 24v 2.54A Operating temperature 80 degrees celsius, -20 degrees celsius Nominal toque, flow rates and voltages shown in part number description.
Harrier Fluid Power Ltd T/A Flowfit, Parys Road, Ludlow Business Park, Ludlow, Shropshire, SY8 1XY, United Kingdom, Phone: 01584 876 033 Fax: 01584 876 044 Company Reg No 3174819, Registered in England and Wales VAT Registration NO:682249809